Bell Sanction 2 Liner Set – Genuine Bell Replacement Helmet Pads

Replace your worn, dirty, or smelly helmet padding with a genuine Bell Sanction 2 replacement liner set. These replacement pads are designed specifically for the Bell Sanction 2 bicycle helmet and provide a comfortable, fresh fit.

The genuine Bell replacement liner set is washable, comfortable, and helps keep your helmet feeling fresher and more comfortable.

Features

• Genuine Bell replacement part

• Replacement liner/pad set for the Bell Sanction 2 helmet

• Comfortable replacement padding

• Washable to help keep your helmet fresh

• Designed to replace worn, dirty, or damaged original padding

Important Installation Information

The original helmet pads are attached using Velcro® or double-sided adhesive, depending on the helmet. The original Velcro or adhesive is not included with this replacement liner set.

If you need replacement adhesive, we offer an 18-pack of aftermarket adhesive dots. Each adhesive dot is approximately 0.59" in diameter.

To install adhesive dots:

1. Clean the helmet surface thoroughly.

2. Peel off the protective backing.

3. Position the adhesive dot and press firmly into place.

Important: Adhesive strength may be reduced if the adhesive is removed and reapplied. Continuous exposure to sunlight or heat may also weaken the adhesive.

Please verify that your helmet is a Bell Sanction 2 before ordering.